25 Results
View results:
Sort by:
Steady-State or Transient Simulation for Parapet in RWIND
What is the most accurate CFD method for the wind simulation of parapets?
Question
How is the automatic creation of c/t-parts carried out?
Question
For the cross-section design of a flat steel, I obtain abnormally high shear stresses due to the torsion in the STEEL EC3 add-on module, which can be disproved by a simple manual calculation. What is the error?
Export | Export cutting patterns
Can I export my cutting pattern?
Question
How can I perform the stability analysis in RF‑/STEEL EC3 for a flat bar supported on edges, such as 100/5? Although the cross-section is rotated 90° in RFEM/RSTAB, it is displayed as lying flat in RF‑/STEEL EC3.
Question
How is an inflatable object simulated in RFEM?
Question
How can I define a material allowance at the edge of a cutting pattern?
Question
I have entered cross-sections U180 and a flat steel 30 x 300. Unfortunately, I cannot connect the cross-sections together, and no related cross-section is calculated.
Question
How is it possible to create the cutting pattern geometry for a decorative sticker on a biaxially curved membrane roof?
Question
I would like to design a cross-section in RF‑/STEEL Cold‑Formed Sections that is not contained in the cross-section library of RFEM/RSTAB. What should I do?
Question
Why does the direction of a cutting pattern edge line in the support area change abruptly?
Question
Which roof and ground plan shapes can be considered with the wind and snow load generators of RFEM/RSTAB?
Question
Is it also possible to design flat slabs in RF‑TENDON and RF‑TENDON Design?
Question
How can I recognize that the RF‑CUTTING‑PATTERN flattening process has found the convergence?
Elastic critical moment for lateral-torsional buckling
What are the options in RFEM 5 or RSTAB 8 for determining the ideal elastic critical moment for lateral-torsional buckling for any cross-sections and systems/loads? Is it also possible to design flat steel (brackets, flat steel stringers of staircases)?
Question
How can I correct Error No. 1663 referring to a missing rib entry in the member definition?
Question
How can I smooth continuous boundary lines of membrane cuttings?
Question
How can I flatten the shape found using RF‑FORM‑FINDING?
Question
Which length is used for the distribution of the boundary line compensation in a surface?
Question
Why is the compensated cutting pattern length of a membrane surface incompatible with the defined compensation?
Why is the compensated cutting pattern length of a membrane surface incompatible with the defined compensation?